Discounts: 5% from 100 €, 10% from 200€, 12.5% from 350€
We are moving! There may be delays from 23 September - 4 October 2024.
HOME WHIRLPOOL General Info
Information
Information about whirlpool systems - notices and advices of system design and installation of the components
The following images will take you directly to the appropriate sections.
Direct to Bottom Air Spa Systems direct to Side Water Hydro Systems to Outside Pools Hot Tub Systems
Information about air systems:
The Air Spa Bottom system needs safty devices to prevent water of getting into the blower. The double loop (3) is
one device, the fixing of the manifold (4) on a position above the maximum Water level a second.
The Push-Fit connection is easy and can be opend again.
The D.I.Y Whirlpool Kit is here: LINK
Alternative - with check - non-return valve:
Take a look at the following video:
Cutting model of a acrylic bathtub:
Sample for trial drilling available in shop - LINK
Information about water systems:
Hydromassge Jet installation with 25 mm Hose / Clip water supply. Easy and safe installation. Hose and Clip for water and air on the jet, as well as on the pump with special 25mm T-Fitting for the outlet and the venturi air of the jet to the 13mm double connection air regulator.
The Set full Set is here: LINK
This hydromassage principle is for the following jets: ASV
Outside Whirlpool Jacuzzi Hot Tub System
Use a cap, if your system is finished or go to the next manifold.
The air hose (orange ) is conected between the 3/8" (10mm) jet venturi connection and the manifold.
The venturi air can be controlled with device while the usage.
The suction in hot tubs has to be double to divide the suction force of the pump:
Whirlpool jet diveter in the system
The massage pump is supplied with water from the suction. The exit of the pump goes to
the diverter. The diverter makes it possible, to adjust the massage intensity in the two sections.
From 100 % at one exit to 100 % to the other side - or 50/50 both sides open.
Air Spa in Hot tubs and Outside Whirlpools
For the installation of the air system in the bottom, the air systems (see top) are suiteable, but only in the execution of plastic or stainless steel. Because the water remains constantly in the pool, chromed brass is unsuitable.
Air jet kit: LINK
The air blower must be designed for larger water depths than in the bath (more than 60cm) .
The following blower is suitable up to a water depth of 1.0 m Blower A700
Modular Whirlpool Kits
The following Whirlpool for do it yourself installation is avaiabee in modular kits:
DIY Modul with 6 side jets: LINK
DIY Modul with 4 bigger massage jets (4"): LINK
Whirlpool DIY modul with 12 Massage jets LINK
Whirlpool DIY modul back massage LINK
Whirlpool DIY kit with pump and suction LINK
This kit is an idea how a whirlpool can be installed or the components can be assembled.
Options:
Push-Up Speaker
